Reinforced Concrete Structure (R.C.C.) Design questions For SSC JE


31.  The reinforcement bars are generally bent


   A. By heating

   B. By welding

   C. Manually by using a lever

   D. By casting in slope


✔ View Answer


C. Manually by using a lever

✍ Your Comments

Your name:

Your Email:

Your Comments:



32.  In case of past tensioned prestressed concrete beams another cones are designed primarily for


   A. Torsion

   B. Hoop tension

   C. Hoop compression

   D. Bearing compression


✔ View Answer


B. Hoop tension

✍ Your Comments

Your name:

Your Email:

Your Comments:



33.  Usually the thickness of floor slabs for buildings is not less than


   A. 11 cm

   B. 10 cm

   C. 9 cm

   D. 12 cm


✔ View Answer


C. 9 cm

✍ Your Comments

Your name:

Your Email:

Your Comments:



34.  In port tensioned pre-stressed concrete members, spalling stresses are produced at


   A. Bond zone

   B. Anchorage zone

   C. Maximum shear zone

   D. Maximum bending moment zone


✔ View Answer


C. Maximum shear zone

✍ Your Comments

Your name:

Your Email:

Your Comments:



35.  As compare to an over reinforced section, an under reinforced section is preferred because


   A. There is less chance of failure

   B. It is more economical

   C. It causes only compression failure for which the chances are least

   D. It cause tension failure for which the chances are generally less


✔ View Answer


D. It cause tension failure for which the chances are generally less

✍ Your Comments

Your name:

Your Email:

Your Comments:






< 1 2 3 4 5 6 7 8 9 10 Next>






Enter Your Suggestion/Comments Here










Can't read the image? Click here to refresh