Interview Questions On Reinforced Concrete Structure (R.C.C.) Design Pdf

36.  In which of the following construction, the unit mould method is used ?

   A. Precast construction

   B. Cantilever construction

   C. Post tensioned construction

   D. Cast in situ construction

37.  In which case the maximum value of span/depth ratio would be least

   A. Simply supported slabs spanning in one direction

   B. Simply supported slabs spanning in two directions

   C. Continuous slabs spanning in two directions

   D. Cantilever slabs

38.  In case of a T-beam, the position of neutral axis

   A. Always lies somewhere in the web area

   B. Always lies somewhere in the flange area

   C. Is always outside the cross-sectional area

   D. May be anywhere in the cross-section

39.  Partial safety factor on steel stresses is

   A. 1.25

   B. 1.35

   C. 1.15

   D. 1.50

40.  The spacing of vertical stirrups in a rectangular beam is

   A. Maximum near the centre

   B. Minimum near the centre

   C. Minimum near the supports

   D. Maximum near the supports

< 1 2 3 4 5 6 7 8 9 10 Next>